Publicité
4663AFDH ASSEMBLY INSTRUCTIONS
Hex Wrench (provided), Phillips Screwdriver, Mallet or Padded Hammer, Wood Glue
Fig. 1
NOTE: Bolts should only be finger-tightened in this step.
1. Place both Long Safety Rails (G) face-down on a clean, protected surface. Position two Rail Braces
(I) over the pre-drilled holes and insert eight 6x35mm Black Hex Bolts (L). See Figure 1.
Fig. 2
Fig. 2a
NOTE: Bolts should only be finger-tightened in this step.
2. Determine if you want the access to the upper bunk to be on the left or right side of the bed.
Figure 2 shows the ladder attaching on the right to access the top bunk.
Place both Short Safety Rails (H) face-down on a clean, protected surface. Position two Rail
Braces (I) over the pre-drilled holes and insert eight 6x35mm Black Hex Bolts (L). See Figure 2.
For left-access, rotate the Short Safety Rails (H) 180 degrees and attach the Rail Braces (I) with
eight 6x35mm Black Hex Bolts (L). See Figure 2a.
All manuals and user guides at all-guides.com
TOOLS REQUIRED:
L
G
L
H
L
I
I
H
I
H
H
x 8
L
L
L
L
4663AFDH – Page 4 – 02/09
Publicité
