Publicité
Fig. 5
5. Roll out one Slat Assembly (C) and position it on to the bottom edge of the Side Rails as shown
in Figure 5. Center Slat Assembly (C) and anchor one end with 4x35mm Flat Head Screws (P). Pull
the opposite end slat towards the opposite headboard so that the webbing in between the slats is
drawn taut. Secure that end slat to the rails with two 4x35mm Flat Head Screws (P). Secure the
remaining slats to the side rails with 4x35mm Flat Head Screws (P). See Figure 5.
Q
Note: Bolts should only be finger-tightened in this step.
6. Attach the Short Safety Rail assembly to the side of the Upper Bunk assembly that will not be
placed against a wall with four 6 x 45mm Black Hex Bolts (Q). See Figure 6.
All manuals and user guides at all-guides.com
P
C
Fig. 6
x 28
P
x 4
Q
4663AFDH – Page 6 – 02/09
Publicité
