Kenwood Multipro FP720 Serie Instructions page 9

To use the large feed tube - use both pushers together.
5 Put the food in the feed tube.
6 Switch on and push down evenly with the pusher - never
put your fingers in the feed tube.
hints
Use fresh ingredients
G
Don't cut food too small. Fill the width of the large feed tube
G
fairly full. This prevents the food from slipping sideways
during processing. Alternatively use the small feed tube.
When using the chipper disc, place ingredients horizontally.
G
When slicing or shredding: food placed upright
G
out shorter than food placed horizontally
There will always be a small amount of waste on the plate or
G
in the bowl after processing.
m u
lt i
p ro
citrus press
Use the citrus press to
squeeze the juice from
citrus fruits (eg oranges,
lemons, limes and
grapefruits).
cone
sieve
to use the citrus
press
1 Fit the drive shaft and bowl
onto the power unit.
2 Fit the sieve into the bowl -
ensuring the sieve handle is
locked into position directly
over the bowl handle .
3 Place the cone over the
drive shaft turning until it drops all the way down
4 Cut the fruit in half. Then switch on and press the fruit onto
the cone.
The citrus press will not operate if the sieve is
G
not locked correctly.
All manuals and user guides at all-guides.com
comes
.
m u
lt i
p ro
m u
lt i
p ro
.
7
mill
Use the mill for milling herbs, nuts and
coffee beans.
blade unit
sealing ring
jar
mill lid
safety
Never fit the blade unit to your machine
G
without the jar fitted.
Never unscrew the jar while the mill is
G
fitted to your machine.
Don't touch the sharp blades. Keep the
G
blade unit away from children.
Never remove the mill until the blades have
G
completely stopped.
important
To ensure long life of your mill, never run for
G
longer than 30 seconds. Switch off as soon as
you've got the right consistency.
G Don't process spices - they may damage the
plastic.
The machine won't work if the mill is fitted
G
incorrectly.
Use for dry ingredients only.
G
to use your mill
1 Put your ingredients into the jar.
Fill it no more than half full.
2 Fit the sealing ring into the blade
unit.
3 Turn the blade unit upside down.
Lower it into the jar, blades
down.
4 Screw the blade unit onto the jar
until it is finger tight.
5 Place the mill onto the power unit
and turn to lock .
6 Switch on to maximum speed or use the pulse control.
hints
Herbs are best milled when clean and dry.
G
m u
lt i
p ro