Silverline HO0002 006 Instructions De Montage page 20

ASSEMBLY OF PRODUCT
Preparing the Device
4,8 x 50 mm
Fig. 13
20
Draw a mid location line from the ceiling perpendicular to the
1.
lower edge of the hood (Fig. 12).
There is a tab in the middle of the flue connection plate.
2.
Place the middle point of this tab on the line that is drawn
perpendicular to the wall. Align horizontally and mark the
holes where the connection plate will be mounted via a pen
(Fig. 12/a).
Drill the marked points with Ø6mm drill and insert 2xØ6mm
plastic dowels in the drilled holes (Fig. 12/a).
Fix the flue connection plate to the wall with 3,9x22 screws
(Fig. 12/a).
To drill the suspension holes of the flue, place the mounting
3.
template on the surface where the appliance will be mounted
on and mark the mounting holes (Fig. 12/b).
Drill the suspension holes with Ø8mm drill and place the
4.
dowels (Fig. 12/b).
Place 2x4.950 suspension screw with a clearance of 5 mm
between the screw head and the wall (Fig. 12/b).
It is necessary to open the filter.

Open the metal oil filters.

( ).
If the air discharge pipe radius is less than150mm, mount

Ø150/120 mm flue adapter.
Hold the appliance by its body and place it on the suspension
1.
screws on the wall and tighten the screws (Fig. 13).
Fix the appliance with 4.8x50 screws through the mounting
2.
hole on the interior of the appliance (Fig. 13).
Insert the appliance aluminium oil filter.
3.
If the appliance will be used without a carbon filter, mount the
air discharge pipe.
HOOD USER GUIDE ENGLISH 23.02.2023