Viking VIPR101 Mode D'emploi page 9

viking range corporation
inStaLLation oF reMote controL SWitcH
Warning: to reduce the risk of burns or ignition
of clothing by reaching across burners, the remote
control must be mounted at least 4" away from any
cook top burner.
keep in mind you do not want to place the control where it
will be in the way for cooking, or where hot pans could be
set, or hot liquids spilled on the control.
1. Using t he t emplate b elow, l ay o ut t he 3 -hole p attern o n t he c ounter
top. Mark the centers of the three holes to be drilled.
2. Carefully drill the three holes through the counter top. Be careful
not to damage or chip the counter top surface when drilling the
holes.
All manuals and user guides at all-guides.com
TOP EDGE
1/4" DIA.
HOLE
CUT OUT ON DOTTED LINE
3. Remove the control from the plastic bag. Remove the paper from
the adhesive back of the control, line the control up with the three
holes and position the control so it is parallel with the front of the
counter top. Press down firmly for 60 seconds.
4. Remove the two nylon thumbnuts from the plastic bag and thread
onto t he t wo s tuds o n t he c ontrol f rom b elow t he c ounter t op. H and
tighten only. The thumbnuts just need to be snugged by hand.
They are there to hold the control in place until the adhesive sets
up.
5. Remove cable from the plastic bag and plug into back of control
from below counter top. Route cable through cabinet to lower
right hand corner of downdraft. Plug other end of cable into the
downdraft unit. (Receptacle hole for cabinet is on the lower right
hand side of the downdraft.)
6. Stuff excess cable out of the way and secure the cable so it is not
damaged from items stored in the cabinet.
1/4" DIA.
HOLE
5/8" DIA.
HOLE
9
downdraft Ventilators