Choosing Another Resolution; Metric/Inch Conversion - Hexagon TESA DIGICO Série Mode D'emploi

The TOL mode allows you to enter both upper and lower
tolerances. The nominal value is defined through the PRE-
SET value. Each tolerance value is absolute.
Example
Nominal value to be measured (PRESET)
Tolerance
Lower tolerance
Upper tolerance
Whenever the measured values are lower or higher than
the given limit values (out-of-tolerances), display shows
both symbols
Once mode TOL defined, unequal
will apply on all other modes.

Choosing another resolution

For additional information, report to page 7.
The chosen resolution depends on used model. With re-
spect to this, refer to the technical data.

Metric/Inch conversion

For additional information, report to page 7.
Switching from the metric to the inch unit system is pos-
sible at any time. Your Digico will automatically calculate
the matching value.
accordingly.
/
+
+40,000 mm
±0,010 mm
+39.,90 mm
+40.010 mm
000.000 mm, this one
-
13