Publicité
Les langues disponibles
Les langues disponibles
Press the power
blink.
Use the up
selected the hour, press the
Use the up
and down
When you are satisfied with the programed START time press the
OFF will be displayed on the left of the screen and a large OFF will be flashing in the center
of the screen.
power
button to activate the STOP timer. The hour will begin to blink.
the up
and down
the set
button and the minutes will begin to blink.
SET
down
buttons to select the minutes. Once you are satisfied with your selections, wait
ten seconds and the VSC will return to time of day display, indicating that programming
was entered.
To deactivate the START/STOP timer features, repeat the programming steps and press the
power button when the START and STOP times are flashing. The time will be replaced with
a large OFF, indicating the timer is deactivated.
Maintenance and Inspection
Regular maintenance and inspections are recommended to determine that everything is
operating properly. If any abnormal conditions are noticed, refer to the section on
Troubleshooting and take corrective measures immediately.
Winterization
The TidalWave Variable Speed Controller should be removed and stored inside to protect it
during the winter. Please refer the specific winterization instructions for the pump installed
with the TidalWave VSC.
Warranty
The TidalWave Variable Speed Controller carries a three-year limited warranty. This limited
warranty is extended solely to the original purchaser commencing from the date of
original purchase receipt and is void if any of the following apply:
• The VSC was used in conjunction with a magnetic induction or direct drive pump.
• The VSC was not run on a dedicated circuit.
• The cord has been cut or altered.
• The VSC has been misused or abused.
• The VSC has been disassembled in any way.
• Serial number tag has been removed.
Warranty Claims
In case of warranty claims, return the VSC to the place of purchase, accompanied by the
original receipt.
button to activate the START timer. The hour will begin to
and down
set button and the minutes will begin to blink.
SET
buttons to select the minutes.
This indicates that the STOP timer is currently turned OFF. Press the
buttons to select the hour. After you have selected the hour, press
buttons to select the hour. After you have
set button. A small
SET
Use the up
and
Use
5
Publicité
