Aastra DT390 Guide De Référence Rapide page 5

All manuals and user guides at all-guides.com
FCC Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules.
These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV techni-
cian for help.
--------------------------------------------------------------
Privacy of communications may not be ensured when
using this phone.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
device complies with FCC SAR limit of 1.6 W/kg. The high-
est SAR value measured when used at the ear is
0.104 W/kg. This device must not be colocated or operat-
ing in conjunction with any other antenna or transmitter.
• This equipment complies with Part 68 of the FCC rules
and the requirements adopted by the ACTA. On the rear
side, underneath the battery of this equipment is a label
that contains, among other information, a product iden-
tifier in the format US:AAAEQ##TXXXX. If requested, this
number must be provided to the telephone company.
• REN is N/A as this product is intended to be connected
behind a FCC Part 68 compliant PBX system. It is not
intended for direct connection to telephone network.
• If this equipment cause harm to the telephone net-
work, the telephone company will notify you in advance
that temporary discontinuance of service may be
required. But if advance notice isn't practical, the tele-
phone company will notify the customer as soon as pos-
sible. Also, you will be advised of your right to file a com-
plaint with the FCC if you believe it is necessary.
• The telephone company may make changes in its facil-
ities, equipment, operations or procedures that could
affect the operation of the equipment. If this happens,
the telephone company will provide advance notice in
order for you to make necessary modifications to main-
tain uninterrupted service.
• If trouble is experienced with this equipment, for repair
or warranty information, please contact your Aastra
business partner http://www.aastra.com.
This equipment is not intended to be repaired by the
customer (user). If the equipment is causing harm to the
telephone network, the telephone company may
request that you disconnect the equipment until the
problem is resolved.
• Connection to party line service is subject to state tar-
iffs. Contact the state public utility commission, public
service commission or corporation commission for infor-
mation.
• If your home has specially wired alarm equipment con-
nected to the telephone line, ensure the installation of
this equipment that it does not disable your alarm
equipment. If you have questions about what will disa-
ble alarm equipment, consult your telephone company
or qualified installer.
Electrical Safety Advisory
Electrical surges, typically lightning transients, are very
destructive to customer terminal equipment connected
to AC power sources. Customer is thus recommended to
use a surge arrestor for the equipment that requires
AC power.
5