Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
must be a direct separate line from the overflow fitting to a drain, sewer or tub. Allow an air
gap as per drain line instructions.
Add salt to brine tank. You can fill this up to the top of the tank. Add 3-4 litres of tap water from
8.
your kitchen tap on top of the salt.
IMPORTANT: There must be 15cm of salt in your tank at all times. Refill the brine tank at
regular intervals. A bag of salt lasts approximately 4-6 weeks.
9.
Configure the setting on control valve. A full, step-by-step, guide on control valve configuration
follows.
10. After configuring the settings turn on the mains water. Turn on cold tap in the kitchen sink.
There may be air in the pipes so let the water run for 3-4 minutes.
11. Check for leaks. We recommend regular checks for leaks for the first 24 hours after install.
IMPORTANT: Check for leaks at all joints and connections after turning on the mains water.
After 3 hours check for leaks at all joints and connections.
We recommend a further check after 24 hours.
CONFIGURING THE SETTINGS ON AQUASMART
Familiarise yourself with the keypad and adjusting the settings.
Diagram 3
The diagram shows the digital keypad and the manual back wash
dial for AS200, AS500 and AS800 models.
After you become familiar with the keypad buttons. Enter the settings suitable fro your home.
Press
the 'Menu' button to begin.
TM
WATER SOFTENERS AS200, AS500, AS800
Press
•
Press
•
Press
•
can be edited.
Press
•
Press
•
Press
•
item.
Repeat the above steps to change
•
another value.
Press
•
You can only change the flashing
parameters.
The menu will return to standby after one
minute of non-use. The screen will lock after
three minutes of non-use.
This control valve is capable of displaying
metric units and US gallons. This manual is
in metric format so we recommend you
select the default metric.
(1 UK gallons = 4.5 Metric litres)
When power is first supplied, the valve will
take 2 minutes to initialise.
Water2buy.com Aquasmart™ v3
to enter the menu.
to select a menu item.
the value starts flashing and
to change the value.
to save the setting.
to select the next menu
to exit settings.
7 / 53
Publicité
