Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
o
Under your kitchen sink
Outside wall of your house
o
In the pump-house
o
o
In the basement
The distance between the unit and a drain
should be as short as possible.
Since salt must be added periodically to the
brine tank, the location should be easily
accessible.
ASSEMBLING YOUR NEW AQUASMART
Refer to diagrams 1 & 2 on
the next page during the
assembly. Diagram 3 gives
an overview on how the
water softener fits into your
water system.
Fit the bypass assembly.
AS200, AS500, AS800 Only.
Add the plumbing fittings.
AS200, AS500, AS800 Only.
Note the water flow
direction arrows.
Open the bypass valves.
AS200, AS500, AS800 Only.
Brine suction hose.
Important. The brine suction
hose (iv) may already be
connected, however you
should complete these
checks as fittings regularly
become loose in transport.
Adjust the mixing valve.
Connect the meter cable.
AS200, AS500, AS800 Only.
Connect the power supply.
Low temperature. Do not locate unit where it or its
•
connections (including the drain and overflow lines) will
ever be subjected temperatures less than 1
or greater than 49
Environment. Do not install unit near acid or acid
•
fumes. The use of resin cleaners in an un-vented
enclosure is not recommended
TM
WATER SOFTENER.
Remove the water softener lid by pulling up. Take out the power supply,
documentation, and any plastic packaging.
Fit the bypass assembly (A) onto the control valve (B). All o-rings (C) should be
lubricated with the silicon lubricant packet included in the power supply box.
Secure the bypass assembly to the control unit on both sides using the bracket
screws supplied. (D)
Add the plumbing fittings (E).
Remove the red fastened clips (F).
Apply silicon lube to the o-rings (G).
Push the o-rings into the bypass assembly (G).
Put back on the red fasteners (F).
Check the water flow direction arrows on the control valve (H) before connecting
the softener to your water supply. The flow direction arrows must match the
direction of your water flow.
Open both bypass valves. (I)
Use the tool supplied to turn the red bypass valves fully clockwise.
The valves are open when both are parallel.
NOTE: Failure to open these will bypass the water softener leaving you with
hard water.
Connect the white brine suction hose (iv) to the control unit (J). Tighten to an
airtight seal. Tighten with your hand, then tighten airtight with a wrench.
Use a wrench to tighten the brass nut on the control unit.
Check that the other end of the brine suction hose is connected securely inside
the brine tank to the grey brine suction pipe. The Grey brine suction pipe on the
inside should be wedged at the size of the blue vessel. The flotation buoy end of
the grey pipe should be on the bottom of the brine tank.
NOTE: Loose seals on the brine suction hose if the most common cause of the
unit malfunctioning.
The mixing valve (K) should be turned fully anti-clockwise in order for your unit to
produce fully soft water. NOTE: the mixing valve is an option on some units.
Your unit may not have a mixing valve.
The meter cable (vi) should slot into the bypass assembly socket (L) and click
firmly in place.
Connect he power cord and plug-in the power supply (vii).
Water2buy.com Aquasmart™ v3
o
C (34
o
o
C (120
F).
4 / 53
o
F)
Publicité
