Bosch DWM 40 L Mode D'emploi page 6

All manuals and user guides at all-guides.com
dwm40_bu_1609929990_t.fm5 Seite 9 Montag, 3. Juli 2000 3:54 15
Determining of Bevel and
Miter Angles for the Cutting
of Crown Moldings
Note: Perform the measurements without
delay since the unit switches off automatically
after 5 minutes without activity.
Observe exactly the sequence of the following
steps.
If an angle is measured that is outside the al-
lowable range when measuring the spring an-
gle or corner angle, "– – – –" appears in the
display and the unit reverts to the normal
measuring mode after approx. 10 seconds.
Allowable ranges:
for spring angle: 26° – 60°
for corner angle: 60° – 150°
Procedure
Setting the Spring Angle
Set the known spring angle on the unit.
Ceiling
Spring Angle
For this purpose, open the legs so wide that
the value of the spring angle is displayed, e.g.
38°.
Store this value setting by pushing the BV/MT
button.
The entry is confirmed by the appearance of
"SPR" in the display.
Note: If the spring angle is not known, it must
be determined; see Section Determining the
Spring Angle.
9