Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
dwm40_bu_1609929990_t.fm5 Seite 7 Montag, 3. Juli 2000 3:54 15
Display Elements
a Angle display
b Battery indicator
c Spring angle indicator
d Corner angle indicator
e Miter angle indicator
f Bevel angle indicator
g Hold indicator
When the battery indicator (
measurements are still possible for approx.
1 – 2 hours.
When the indicator blinks, the batteries must
be replaced. Measurements are no longer
possible.
Area of Application
The unit is a precision tool for the measuring
and transferring of angles (horizontal/vertical),
e.g., for made-to-measure fabrication in inte-
rior construction, stairs construction, exterior
coverings, etc.
Spare Parts
Battery compartment cover . 1 609 203 928
End cap . . . . . . . . . . . . . . . . 1 609 203 770
Joint cover . . . . . . . . . . . . . . 1 609 203 927
Putting into Operation
Insert the batteries before putting into
operation for the first time.
Slide the battery compartment cover 4 in the
direction of the rectangle point and open.
When inserting the batteries, take care that
the polarization is correct (see Fig. B).
The unit is automatically switched on after the
insertion of the batteries. For checking of the
display, all segments of the angle display ap-
pear for approx. 20 s. The current angle is
then displayed.
Switching On/Off
– On: Press button 11.
All segments of the angle display appear
briefly.
– Off: Press button 11 again.
After 5 minutes without button actuation or
angle change, the unit switches off automati-
cally to preserve the batteries.
) appears,
– +
7
Publicité
