Bosch C-IR 20 Notice D'installation Et D'utilisation page 38

Installation
Dimensions
The dimensions are shown in Fig. 2 at the end of the document.
Clearances
The clearances are shown in Fig. 5 at the end of the document.
3.3 Installing the control
The installation steps and electrical connection are shown in Fig. 3 at the end of the
document.
The electrical connection is shown in Fig. 6 and, according to the power used, Fig. 7
or Fig. 8 at the end of the document.
The thermostat power supply must be disconnected when inserting the display part
(screen) into the base or removing it from the base. Failure to follow this instruction
may result in an irreparable damage to the thermostat.
3.4 Electrical connection
WARNING
Risk to life from electric shock!
Touching live electrical parts can cause an electric shock.
▶ Before working on electrical parts, disconnect all phases of the power supply
(fuse/circuit breaker) and lock the isolator switch to prevent unintentional
reconnection.
▶ The electrical circuit in which the thermostat is connected must be protected by
a circuit breaker with a tripping current of max. 16A.
38
C-IR 20 – 6721851970 (2023/10)