Publicité
Les langues disponibles
Les langues disponibles
1
PREPARATION
a. Turn the water supply OFF.
b. Install or relocate the supply tubing and waste pipe as necessary to conform to the roughing in dimensions.
c. Install the shut off valve.
d. Install adequate support framing for the wall hangers as needed.
e. Determine the position of the waste pipe nipple. When establishing the nipple length, take into account the
length of the urinal outlet spud and the distance the female collar will thread onto the waste pipe nipple.
NOTE: Add a little extra length to the nipple to allow for gasket space.
212mm
(8-3/8")
Wall Hangers
2
INSTALL THE URINAL
!
CAUTION: RISK OF PERSONAL INJURY OR PRODUCT DAMAGE. HANDLE WITH CARE.
VITREOUS CHINA CAN BREAK OR CHIP IF THE PRODUCT IS HANDLED CARELESSLY.
!
CAUTION: RISK OF PRODUCT DAMAGE. DO NOT OVERTIGHTEN THE BOLTS.
a. Install the wall hangers according to the roughing in illustration.
b. Apply thread sealant tape to the pipe threads and install the female collar to the waste pipe.
c. Place the gasket onto the female collar with the beveled surface facing away from the collar.
d. Carefully position the urinal on the wall hangers.
e. Secure the urinal to the female collar using the screws and washers provided.
3
COMPLETE THE INSTALLATION
a. Install the flush valve according to the manufacturer's instructions.
b. Connect the water supply and complete the waste pipe connections.
c. Turn on the water supply.
d. Flush and check the entire installation for leaks.
NOTE: In the event of splashing, adjust the "angle stop" as needed.
CARE & CLEANING
Wash with mild soapy water and rinse thoroughly. Dry with a soft cloth. Avoid detergents, disinfectants or cleaning products in
aerosol cans as they may damage fittings.
STRAINER CARE
Clean urinal with care when a strainer is attached. To prevent damage to the strainer finish, please do not use abrasive cleaning
materials or scouring pads to clean the strainer surface. The use of chlorine bleach (hypochlorite) is not recommended. However,
if bleach must be used, limit the concentration to less than 5%, taking care to rinse the surfaces completely after cleaning.
For warranty information please follow this link:
https://www.americanstandard-us.com/support/warranty
In the United States:
American Standard Brands
30 Knightsbridge Rd., Suite 301
Piscataway, NJ 08854
Attention: Director of Customer Care
For residents of the United States, warranty
information may also be obtained by calling the
following toll free number: (855) 815-0004
www.americanstandard.com
Support
Wall
In Canada:
LIXIL Canada Inc.
5900 Avebury Rd.
Mississauga, Ontario
Canada L5R 3M3
Toll Free: (855) 836-9615
www.americanstandard.ca
Washer
Screw
- 2 -
Installed Wall
Hangers
Female Collar
Gasket
In Mexico:
American Standard B&K Mexico
S. de R.L. de C.V.
Via Morelos #330
Col. Santa Clara
Ecatepec 55540 Edo. Mexico
Toll Free: 800-839-1200
www.americanstandard.com.mx
7302379-100 Rev. 3 8/22
Publicité
