Publicité
Les langues disponibles
Les langues disponibles
On/Off Switch:
Push up to turn On (|). Push down to turn Off (O).
1
Control Panel: For more information, refer to the Control Panel.
2
CAUTION: Lids and tampers are not interchangeable between
different container styles, types and sizes.
2-litre capacity container with 2-part lid:
3
• Always use the lid and the lid plug when the machine is
operating.
• Never operate the blender without the lid securely locked
in place.
• Ounces, Millilitres and Cups are clearly marked.
• Insert the lid plug through the lid and secure by turning
clockwise.
• Remove the lid plug to use the tamper or to add ingredients.
Tamper: Using the tamper maintains circulation by preventing
4
air pockets from forming.
Two Piece Lid: (lid and lid plug)
5
To Lock the Lid in Place: The lid must always be secured when
processing, especially when blending hot liquids that may scald.
Never operate the blender without the lid securely locked in
place. The lid has a continuous rim which latches inside the
container tabs. Push one side of the rim under one tab and
push down over the opposite tab to snap the lid into position.
To Remove the Lid: Place your hands around the lid, pressing
your thumbs above one of the container tabs. Push in and lift
off.
To Remove the Lid Plug: Rotate the lid plug anti-clockwise
from the 'locked' to the 'unlocked' position and lift out.
Power Cable:
The blender's power cable comes equipped with a
6
three-prong (earthed) plug which mates with a standard three-
prong wall socket. This cable will vary for countries outside the
United States of America.
Adapters are available for two-prong outlets. Do not cut or
remove the third (earth) prong from the plug or power cable.
Consult your electrician if you are not sure if the wall socket is
earthed through the building's wiring. With a properly earthed
two-prong wall outlet, earth the machine by attaching the tab
on the adapter to the wall outlet cover by means of the screw in
the centre of the cover.
On/Off Switch: Push up to turn On (|). Push down to turn Off (O).
1.
High/Variable Switch: High ( ) is the fastest speed available. Switch
2.
to Variable (
) to activate the variable speeds. Always make sure
that the High/Variable Switch is set to Variable (
the On/Off Switch to the On (|) position. Do not start your machine on
High ( ) speed.
3.
Variable-Speed Dial: Selects many speed settings. It is active only when the High/
Variable Switch is set in the Variable (
4
P
a r t S a n d
c
o n t r o l
) before lifting
.
) position
f
e at u r e S
4
2
FIGURE A
P
a n e l
2
5
3
FIGURE B
3
1
1
Publicité
