Eneo NXD-980IR37P B Guide D'installation Rapide page 20

Access from the internet
Access from the internet once connected, the Network Camera is accessible
on your local network (LAN). To access the network camera from the Internet
you must configure your broadband router to allow incoming data traffic to
the network camera. To do this, enable the NAT-traversal feature, which will
attempt to automatically configure the router to allow access to the network
camera. This is enabled from Setup > System > Network > NAT. For more
information, please see "3.5.5 System>Network>NAT" of User's Manual.
Setting the admin password over a secure connection
To gain access to the product, the password for the default administrator
user must be set. This is done in the "Admin Password" dialog, which is
displayed when the network camera is accessed for the setup at the first
time. Enter your admin name and password, set by the administrator.
NOTE: The default administrator username and password is
"admin". If the password is lost, the Network Camera must be
reset to the factory default settings. See "Resetting to the Factory
Default Settings".
20
All manuals and user guides at all-guides.com