Kicker KSS50 Manuel D'utilisation page 5

CROSSOVER MOUNTING
Mount the crossover in a location that is easy to access for wiring and tweeter output level adjustment.
Make sure that the crossover will not be exposed to water. The bottom of the car door is not a good
location. If you must mount the crossover in the car door, exercise caution as water can accumulate in the
bottom of the door. Keep the crossover high in the door and shielded from water.
to tweeter lead wires
woofer mounting hole
If factory speaker wiring is not available in your desired location, it may be necessary to run speaker wire
through the door jamb. The speaker wire should be kept away from sharp edges and avoid the possibility of
getting pinched by the door. An existing grommet in the door jamb is the ideal place to run the speaker wire.
If the factory hole and grommet do not exist or are inaccessible, you must drill a hole to run the speaker wire
through the door jamb. Be careful not to drill into other wiring or existing door mechanisms. Any time a wire
is run through a hole, it is necessary to insert a rubber or plastic grommet to protect the wire from damage.
2017 KS Component Rev B.indd 5 2017 KS Component Rev B.indd 5
tweeter mounting hole
to woofer terminals
KS crossover. (mounted
inside door panel)
rubber grommets
door jamb
from amplifi er or
source unit
5
8/23/2016 12:22:40 PM 8/23/2016 12:22:40 PM