Kicker KSS50 Manuel D'utilisation page 4

CROSSOVER & WIRING CONFIGURATION
We recommend using 16 gauge (or larger) wire. The KS Speakers
are rated at 4 ohms and work with any source unit or amplifi er
designed to operate at a 4 ohm load. Make sure your source
unit or amplifi er is rated for 4 ohm operation.
Use the tweeter attenuation switch to adjust the output level of
the tweeter to 0 dB, +4.5 dB, or +9 dB. Higher switch settings will
result in more volume from the tweeter.
Crossover Wiring
One component set per channel
crossover
Crossover Wiring
Two component sets per channel
Crossovers wired in parallel. Make sure your source
unit or amplifi er is rated for 2 ohm operation.
4
2017 KS Component Rev B.indd 4 2017 KS Component Rev B.indd 4
+
-
+
-
-
+
source unit / amplifi er
At least two amplifi er channels are needed for
stereo operation (only one channel is shown)
Requires two complete KS systems
(four woofers, four tweeters, four crossovers)
At least two amplifi er channels
are needed for stereo operation
(only one channel is shown)
8/23/2016 12:22:40 PM 8/23/2016 12:22:40 PM