Télécharger Imprimer la page

Power Fist 9099706 Mode D'emploi page 3

Publicité

Les langues disponibles

Les langues disponibles

V1.0
INTRODUCTION
The filter cartridge in the Auto-Darkening Welding Helmet is designed for
arc welding or cutting applications, including hand welding, gas protected
welding, argon arc welding and plasma cutting.
The solar auto-darkening filter employs photoelectric sensors that cause the
liquid crystal to change from the bright state to dark state as soon as it
receives arc light. The state changes from dark to bright shortly after the
welding is finished. The delay is to protect the eyes and face from harmful
infrared or ultraviolet radiation.
SAFETY
WARNING! Read and understand all instructions before using this tool. The
operator must follow basic precautions to reduce the risk of personal injury
and/or damage to the equipment.
Keep this manual for safety warnings, precautions, operating or inspection
and maintenance instructions.
WORK AREA
1.
Operate in a safe work environment. Keep your work area clean, well-lit
and free of distractions. Place lights so you are not working in a shadow.
2.
Keep anyone not wearing the appropriate safety equipment away from
the work area.
3.
Store unused tools properly in a safe and dry location to prevent rust
or damage. Lock tools away and keep out of the reach of children.
PERSONAL SAFETY
WARNING! Wear personal protective equipment approved by the Canadian
Standards Association (CSA) or American National Standards Institute (ANSI).
PERSONAL PROTECTIVE EQUIPMENT
1.
Always wear impact safety goggles that provide front and side protection
for the eyes. Eye protection equipment should comply with CSA Z94.3-07
or ANSI Z87.1 standards based on the type of work performed.
2.
Do not operate any tool when tired or under the influence of drugs,
alcohol or medications.
Visit www.princessauto.com for more information
Flip-Front Auto-Darkening Welding Helmet
9099706
3

Publicité

loading