Publicité
Les langues disponibles
Les langues disponibles
9099706
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
Irregular
Darkening.
Filter does not
darken or
flickers.
Poor vision.
Welding Cap
slips.
10
Flip-Front Auto-Darkening Welding Helmet
Possible Cause(s)
Headgear is set unevenly so
the distance between the
eyes and the lens is different
from the left to the right side.
1. Front cover lens is dirty or
smoke covered.
2. Arc sensors may be dirty.
3. Welding current is too low.
4. Battery Voltage is too low.
1. Check the clear covers
lenses and the electronic
filter lens for dirt or grime.
2. Protective film was not
removed.
3. Ambient light is not
sufficient to see.
4. Shade Number is not set
correctly.
The headband is not properly
adjusted.
Suggested Solution(s)
Adjust headgear so distance
between the lens and both eyes
are equal.
1. Clean or replace external
lens.
2. Remove external lens and
wipe the photo sensors clean
with soft lint free cloth.
3. Adjust filter sensitivity to the
maximum.
4. Replace the filter cartridge.
1. Clean cover lenses and the
electric filter lens.
2. Remove the protective film.
3. Adjust the work area
lighting.
4. Reset Shade number.
Adjust the Angle Adjustment
Knobs for a tighter fit.
For technical questions call 1-800-665-8685
V1.0
Publicité
