Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT : SCREWS MUST BE TIGHTENED TILL
SNUG
According to the ceiling of different materials, use
different screws to fix the hanging bracket.Don't fix
the hanging bracket on the wood ceiling less than
NOTE
12MM to prevent danger caused by loosening of
screws. After the hanging bracket is completed,
ensure that it can withstand the tension test of
more than 68 kg/150 lbs for safety.
CÖNCRETE CEILING
Mounting
Bracket<A>
For concrete ceiling, use the percussion bit with diameter 8mm to
drill holes according to the length of expansion screws. Then use
the attached expansion screws to fix the hanging bracket onto the
ceiling (selection is made according to actual requirements of the
customers).
10
Expansion Bolts <B>
Flat Washers <C>
Flat Washers <C>
Nuls <E>
STEP 2 A-CONCRETE CEILING
SWITCH OFF THE ELECTRICAL MAINS AT THE CIRCUIT
BREAKER FUSE BOX.
1) Use the Mounting Bracket (A) as a guide, mark the spots
where the Expansion Bolts (B)will be drilled.
2) Remove the Mounting Bracket (A), drill holes and insert
Expansion Bolts (B)into the concrete ceiling, install the mounting
bracket and secure with Flat Washers (C), Spring Washers (D)
and Nuts (E).
IMPORTANT : SCREWS & NUTS MUST BE
TIGHTENED TILL SNUG
Electrical Outlet Box
IMPORTANT: Contact a qualified electrician to
replace the outlet box if it is not suitable for ceiling
cans
□ If there is an existing outlet box,ensure it is clearly marked
"Suitable for Fan Support". if not, it must be replaced with an
approve one.
11
Publicité
