Publicité
Les langues disponibles
Les langues disponibles
WARNING: Each wire not supplied with this fan is designed to
accept up to one12-gauge house wire and two wires from the fan.
If you have larger than12-gauge house wiring or more than one
house wire to connect to the fan wiring, consult an electrician for
the proper size wire nuts to use.
WARNING: Remove the rubber motor stops on the bottom of
the fan before installing the blades or testing the motor.
IMPORTANT: Use the plastic wire connectors(BB) supplied
with your fan. Secure the connectors with electrical tape and
ensure there are no loose strands or connections.
20
2. Making the electrical connections
WARNING :Each wire not supplied with this fan is designed
to accept up to one12-gauge house wire and two wires from
the fan. If you have larger than12-gauge house wiring or more
than one house wire to connect to the fan wiring, consult an
electrician for the proper size wire nuts to use.
WARNING: Remove the rubber motor stops on the bottom
of the fan before installing the blades or testing the motor.
IMPORTANT: Use the plastic wire connectors(BB) supplied
with your fan. Secure the connectors with electrical tape and
ensure there are no loose strands or connections.
1. Raise the fan and place the hangre ball onto mounting bracket.
2. Rotate the fan until the notch on hanger ball snapped into the
slot on mounting bracket and sits firmly.
NOTE : THE DOWNROD AND HANGER BALL SHOULD NOT
ROTATE IF THIS STEP IS DONECORRECTLY.
3.Loose the safety wire calmp.
4.Route the safety wire through the sideFan hole on mounting.
bracket, and retighten the safety wire with safety wire clamp.
5.Connect the wire connector plugs correctly.
The wire connector plugs design with fool proof device, please
don' t force to plug. Other wise it may affect the normal use of the
light fan or burn the fan motor.
21
Publicité
