Coffee Brewing; Hot Water - Saeco Office TWO Mode D'emploi

5

CoFFee BreWinG

Warning! only suitable capsules should be
placed in the capsule compartment.
Do not stick your fingers or any other object in the
capsule compartment.
Warning! single-dose capsules brew a single
coffee/product. Do not use capsules more
than once. the capsule drawer must be emptied after
10 brewing cycles (see section 7).
• During this operation, the green indicator (14) may flash;
this is to be considered as a standard and not a faulty
operating mode.
• Before use, make sure that the dispensing knob (12) is in
the central position and that the water tank of the machine
contains a sufficient quantity of water.
• (Fig. 11) - If the machine is off, switch it on by turning the
power button to "l" position. The green indicator (14) will
flash.
• Wait for the green indicator (14) to be permanently on.
The machine is now ready for coffee brewing.
note: by pressing button (13), the indicator will
be yellow.
5.1 espresso Coffee
• Check if the machine is ready for use.
note: if the indicator light is yellow, press button
(13) once and the light will become green.
• (Fig. 8) - Place a cup under the dispensing spout.
• (Fig. 14) - Raise the lever completely to open the capsule
compartment.
• (Fig. 15) - Insert a single-dose capsule into the compart-
ment as shown in the figure.
• (Fig. 16) - Make sure that the capsule is inserted cor-
rectly.
• (Fig. 17) - Lower the lever completely to close the capsule
compartment.
• (Fig. 18) - To start brewing coffee, turn the knob
clockwise.
• (Fig. 10) - To stop brewing coffee, turn the knob back to
the central position.
• (Fig. 19) - Take the cup.
note: the used capsule will be ejected and
dropped into the relevant drawer (15) only when
the capsule compartment is opened again (Fig. 14).
5.2 long Coffee (American)
The machine allows brewing an American style long
coffee too, thanks to a perfect adjustment of the water flow
passing through the capsule.
• Check if the machine is ready for use.
• Press button (13). The indicator light will flash a permanent
yellow light.
• (Fig. 9) - Place a cup under the dispensing spout.
• (Fig. 14) - Raise the lever completely to open the capsule
compartment.
• (Fig. 15) - Insert a single-dose capsule into the compartment
as shown in the figure.
• (Fig. 16) - Make sure that the capsule is inserted cor-
rectly.
• (Fig. 17) - Lower the lever completely to close the capsule
compartment.
• (Fig. 18) - To start brewing coffee, turn the knob
clockwise.
• (Fig. 10) - To stop brewing coffee, bring the knob back to
the central position.
• (Fig. 9) - Take the cup.
note: the used capsule will be ejected and
dropped into the relevant drawer (15) only when
the capsule compartment is opened again (Fig. 14).
note: to return to the espresso coffee brewing
mode, press button (13).
BeFore PerForMinG Any oPerAtion
DeAlinG WitH Hot WAter DisPensinG,
MAKe sure tHAt tHe WAnD is PositioneD oVer
tHe DriP trAy.
6

Hot WAter

Danger of scalding! Brewing may be preceded by
small jets of hot water. the wand can reach high
temperatures: never touch it with bare hands.
• (Fig. 11) - If the machine is off, switch it on by turning the
power button to "l" position. The green indicator (14) will
flash.
• Wait for the green indicator (14) to be permanently on.
The machine is now ready for hot water dispensing.
• (Fig. 17) - Make sure that the capsule compartment is
closed.
• (Fig. 20) - Place a container or a teacup under the wand
(9), and adjust the drip tray (4) as shown in Fig. 7.
• (Fig. 13) - Turn the dispensing knob anticlockwise
• (Fig. 10) - When the desired quantity of hot water has
been dispensed, turn the dispensing knob back to the
central position.
• 1 •