Publicité
Les langues disponibles
Les langues disponibles
Manual mode
In Manual mode the out-of-level warning of 863G Crosslight™ 3D
Laser is disabled and the laser level can be set at any slope.
1. Remove the laser level from the case and place it on a
solid, flat, vibration free surface or on a tripod.
2. In OFF mode, press the Manual mode button (b) for 2 seconds.
The laser will turn on in manual mode.
In manual mode, the laser beams flashe every 3 seconds.
3. Select the required beams by pressing the beam selector
button (a).
4. Tilt the laser to the desired angle and mark the slope.
5. Slide the ON/OFF Switch (1) to ON mode to activate the
automatic mode.
NOTE:
If the initial inclination of the laser level is above ± 4° and the
automatic mode is activated, the laser beams will flash rapidly and
beep simultaneously. In this case, reposition the laser level on a
suitable horizontal surface.
Pulse mode
In Pulse mode the laser beams will flash at a very high frequency
(invisible to the human eye). This will allow the detector to detect
the laser beams.
Pulse mode is activated when working at extended range or when
it is difficult to see the laser line with the naked eye.
11
Publicité
