User Interface - aqua technix AQUA Plus Timer OKU Instructions De Montage Et D'utilisation

11. AQUA Plus Timer OKU

User interface

(1) Display:
Displays the current time and the status of
the pump, turns its programme mode off after
2 minutes of inactivity.
(2) LED:
Displays the status of the pump even when
the display has been turned off, flashes
when the power supply is established and is
continually lit when the pump is turned on.
(3) "◄" button:
To go back a step in the menu.
(4) "SET/►" button:
To save and to navigate the menu.
(5) "ON/▲" button:
To turn the pump on permanently and to
navigate the menu.
(6) "OFF/▼" button:
To turn the pump off permanently and to
navigate the menu.
There is a back-up battery (type: CR2032)
built into the control for saving the time when
there is no power supply to the pump. This
battery must be replaced after a few years of
operation, if necessary.
Operation
In the start menu there is the possibility to
turn the pump on permanently with the
"ON/▲" button or to turn it off permanently
with the "OFF/▼" button.
When the programme mode is de-activated it
can be turned on by pressing the "▲" button.
The time is displayed. Pressing the button
again will activate the pump permanently.
When the programme mode is activated the
pump turns itself on and off independently.
Pressing the "SET/►" button takes you to
the settings menu. There you can set the
time and programmes P1 to P3.
Pressing the "◄" button always takes you
back to the start menu.
| 16
1
3
5
WG27.50.085-P
WG27.50.086-P
2
4
6