Costway BB5581 Mode D'emploi page 5

Baby High Chair (Stage 1)
Assemble the connectors
Insert the downward groove of connector (3) into the upwards groove of connector (4).
Follow the FIG., Insert one screw (B ) into the hole and tighten with Allen key (H).
Ensure the screws are fully tightened.
P1
Assemble the long legs
Align long leg (5) & (6) with assembled connector.
Insert the barrel nut (E) into the hole in the assembled connector. Ensure the "x" mark
is facing outward.
P1
08
P3
P2
P2
Then insert one fixing screw (C) into the hole in long leg (5) & (6) and tighten with Allen
key (H). Ensure the screws are fully tightened and screw is tight with barrel nut.
Repeat the same procedure for the rest legs.
Ensure to keep the pre-drilled holes at the same side.
P3
WARNING:
Failure to fully tighten screws may cause instability.
Assemble the footrest
Insert the wooden alignment pin(G)in both sides of the footrest, align the footrest(10)
with the pre-drilled holes at the front of the assembled wooden legs.
P1
P4
P2
09