Mitel SMB Information Produit page 11

When Programming Emergency Numbers and
(or) Making Test Calls to Emergency Numbers
• Remain on the line and briefly explain to the
dispatcher the reason for the call
• Perform such activities in the off-peak hours,
such as early mornings or late evenings.
ALLOWING THIS EQUIPMENT TO BE OPERATED
IN SUCH A MANNER AS TO NOT PROVIDE FOR
PROPER ANSWER SUPERVISION IS A VIOLATION
OF PART 68 OF THE FCC's RULES
Proper Answer Supervision is when
• This equipment returns answer supervision
signals to the PSTN when DID calls are
– answered by the called station
– answered by the attendant
– routed to a recorded announcement that
can be administered by the CPE user
– routed to a dial prompt.
• This equipment returns answer supervision on
all DID calls forwarded to the PSTN. Permissi-
ble exceptions are
– a call is unanswered
– a busy tone is received
– a reorder tone is received.
This equipment is capable of providing users
access to interstate providers of operator ser-
vices through the use of access codes. Modifi-
cation of this equipment by call aggregators to
block access dialing codes is a violation of the
Telephone Operators Consumers Act of 1990.
Federal Communications Commission
(FCC) Notice
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when
the equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy; if not
installed and used in accordance with the
instruction manual, it may cause harmful inter-
ference to radio communications. However,
there is no guarantee that interference will not
occur in a particular installation. If this equip-
ment does cause harmful interference to radio
or television reception, which can be deter-
mined by turning the equipment off and on, the
user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer
radio/TV technician for help. The contact
information for the responsible party as
defined in Part 2.909 of the FCC Rules may be
found at:
www.mitel.com/regulatory-declarations.
FOR CANADIAN CUSTOMERS
This product meets the applicable Innovation,
Science and Economic Development Canada
(ISED) technical specifications.
The ISED label identifies certified equipment.
This certification means that the equipment
meets certain telecommunications network
protective, operational, and safety requirements.
ISED does not guarantee the equipment will
operate to the user's satisfaction. The ISED Cer-
tification number is
Mitel SMB Controller
Before installing this equipment, users should
ensure that it is permissible to be connected to
the facilities of the local telecommunications
company. The equipment must also be installed
using an approved method of connection. The
customer should be aware that compliance with
the above conditions may not prevent degrada-
tion of service in some situations.
Repairs to certified equipment should be made
by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alter-
ations made by the user to this equipment, or
equipment malfunctions, may give the telecom-
munications company cause to request the user
to disconnect the equipment.
Users should ensure for their own protection
that the electrical ground connections of the
power utility, telephone lines, and internal
metallic water pipe system, if present, are con-
nected together. This precaution may be partic-
ularly important in rural areas.
or an experienced
IC: 173A-MSMBPLF
11