Mitel SMB Information Produit page 10

CAUTION!
Repairs to this product may be made
only by the manufacturer and its autho-
rized agents, or by others who are legally
authorized. Unauthorized repair will void
this express warranty.
REGULATORY NOTICES
FOR EU AND SWITZERLAND
CE conformity
Mitel Schweiz AG hereby declares that the
Mitel SMB Controller
• conform to the basic requirements and other
relevant stipulations of EMC (2014/30/EU) and
LVD (2014/35/EU) directives.
• are manufactured in conformity with RoHS
according to Directive 2011/65/EU.
The product-specific declarations of conformity
can be found on
declarations.
FOR US CUSTOMERS
This equipment complies with Part 68 of the
FCC rules. A copy of the signed FCC Part 68
SDoC may be found at:
www.mitel.com/regulatory-declarations.
On the rear of this equipment is a label that con-
tains, among other information, the FCC regis-
tration number and ringer equivalence number
(REN) for this equipment. If requested, this infor-
mation must be provided to the telephone
company.
The FCC Registration Number for the equip-
ment is:
Mitel SMB Controller
Port FIC
FXO Loop Start 02LS2
PRI-T1 04DU9-1SN 6.0N N/A
The REN is useful to determine the quantity of
devices you may connect to the telephone line.
Excessive REN's on the telephone line may
result in the devices not ringing in response to
an incoming call. In most, but not all areas, the
sum of the REN's of all devices connected to
one line should not exceed five (5.0). To be cer-
10
www.mitel.com/regulatory-
US: BN2MF01BSMB
SOC REN Jack
N/A 0.1
tain of the number of devices you may connect
to your line, as determined by the total REN's,
contact the local telephone company.
If the equipment causes harm to the telephone
network, the telephone company will notify you
in advance that temporary discontinuance of
service may be required. But if advance notice
isn't practical, the telephone company will notify
the customer as soon as possible. Also, you will
be advised of your right to file a complaint with
the FCC if you believe it is necessary.
The telephone company may make changes in
its facilities, equipment, operations, or proce-
dures that could affect the operation of the
equipment. If this happens, the telephone com-
pany will provide advance notice in order for
you to make the necessary modifications to
maintain uninterrupted service.
There are no user serviceable parts within this
equipment. Refer all servicing to a MITEL autho-
rized repair facility or to MITEL Incorporated. If
you require a MITEL return authorization num-
ber, or information on obtaining service or
repairs, please contact MITEL at the following
telephone number:
1-800-SXMITEL (1-800-796-4835)
A MITEL return authorization number must be
obtained before sending equipment to the
MITEL repair facility.
Repair facility Mitel Networks
If the equipment is causing harm to the tele-
phone network, the telephone company may
request that you disconnect the equipment until
the problem is resolved.
For information concerning repairs that can be
made by the customer, see Troubleshooting
Information. The documentation is shipped with
RJ61X
the system software.
This equipment may not be used on public coin
RJ48C
phone service provided by the telephone com-
pany. Connections to party lines service are
subject to state tariffs. (Contact the state public
utility commission, public service commission
or corporation commission for information).
2160 West Broadway, Suite #103
Mesa, AZ
U.S.A. 85202