Klarstein ANTONIA Mode D'emploi page 25

Dowel
Wall mount
• Pull out the upper part of the chimney to the desired height.
• Mark the mounting holes for the upper wall bracket on the wall and pre-drill
at the marked locations.
• Fix the upper wall bracket to the drilled positions on the wall using 2 dowels
and 2 screws ST4 x 30 mm.
• Fasten the upper part of the chimney to the wall bracket with 2 screws ST4 x
8 mm.
• Place the chimney on the
hood.
• Mark the mounting holes
for the lower wall bracket
on the wall and pre-drill
at the marked locations.
• Fix the lower wall
bracket to the wall with
2 dowels and screws
(4 mm x 30 mm).
Screw
4 mm x 8 mm
Screw
4 mm x 30 mm
EN
25