DELTACALOR DIGITAL THERMOSTAT Manuel D'instructions page 45

OPTIONS
To open the radiator settings, select OPTIONS from the settings menu, using the
navigation key.
Press to open the corresponding menu; use the
through the menu. To go back to the settings menu, select CANCEL and press
confirm.
TEMPERATURE SENSOR CALIBRATION
This function enables you to calibrate the temperature measured by the sensor. Select
CALIBRATION from the options menu, then press
ADAPTIVE START CONTROL
ENABLING
You can use this function to enable/disable adaptive start control. Select ITCS from the
options menu, then press
DESCRIPTION
This function enables you to start the system in advance (maximum 2 hours) when the
thermostat is in
time, according to the weekly programme that is running.
In order to work properly, the ITCS system measures the system's heating speed so that
it can calculate the exact time at which to switch the system on. A default value of 1 hour
will be used initially, but this will be updated automatically over time.
When the system performs an adaptive start, the
To perform the process correctly, you need to:
• Position a thermometer at the same distance from the floor
as the thermostat and check it after 30 minutes.
• Enter the correct temperature using the
• Press to confirm.
to make changes.
mode, thus ensuring the desired temperature at the programmed
navigation key again to scroll
to make changes.
Select enable using the
keys. Press
Select disable using the
keys. Press
ITCS icon appears on the screen.
45
to
and keys.
and
to enable ITCS.
and
to disable ITCS.
EN