Automatic Operation; Sound-To-Light Mode; Turning And Swivelling Direction/Display Alignment - Renkforce Moving Head Notice D'emploi

c) Automatic Operation
In automatic mode, the device works according to the command sequence pre-programmed in the fac-
tory.
• Press ESC (7) repeatedly until Auxx appears (xx defines the automatic operating mode).
• Select the desired automatic operating mode with the buttons UP (8) or DOWN (9) and confirm your input
with the button ENTER (10).
Au01 = Automatic mode slow
Au02 = Automatic mode fast
d) Sound-to-Light Mode
In Sound-to-Light mode, the moving head reacts to the music signals that are detected by the integrated
microphone. This causes the moving head to generate a light show in time to the music.
• Push the button ESC (7) repeatedly until SnoF or Snon appears.
• Select the desired operating mode with the buttons UP (8) or DOWN (9) and confirm your input with the
button ENTER (10).
SnoF = Sound-to-light mode deactivated
Snon = Sound-to-light mode activated
With the sound-to-light mode on, the display MIC (6) will light up.
e) Turning and Swivelling Direction/Display Alignment
Since the moving head can be set up or hung up, the rotating and swivel directions and the display align-
ment can be reversed accordingly.
Rotating direction PAN
• Push the button ESC (7) repeatedly until rPoF or rPon appears.
• Select the desired rotating direction with the buttons UP (8) or DOWN (9) and confirm your input with the
button ENTER (10).
rPoF = normal rotating direction
rPon = inverted rotating direction
Swivel direction TILT
• Push the button ESC (7) repeatedly until rtoF or rton appears.
• Select the desired swivel direction with the buttons UP (8) or DOWN (9) and confirm your input with the
button ENTER (10).
rtoF = normal swivel direction
rton = inverted swivel direction
32