Publicité
Les langues disponibles
Les langues disponibles
Connect Condenser to Boiler Lid.
Step 1. Remove the brass nut
and silicone washer.
Step 2. To ensure a complete
seal, wrap Teflon tape tightly
around the threaded end of the
connect a few times.
Step 3. Slide the silicone washer
up to the fixed-in-place nut. Then
insert the connector in the boiler
lid. The silicone washer remains
down the boiler lid.
Step 4. Thread brass nut onto
threads and tighten (avoid
over-tightening). The brass nut
will be on the underside of the
boiler lid.
Step 5. Thread brass nut
connect to the stainless steel
pipe.
12
Fixed-in-
place Nut
Silicone
Washer
Brass Nut
Silicone
Washer
Silicone
Washer
Brass Nut
Copper
Connection
SET UP WATER FLOW TO CONDENSER
Provide a continuous source of cold water to the condenser pot. The
cold water flowing into the condenser
Pot cools the distillate flowing through the copper coil.
There are two methods:
Method 1. Home faucet method:
Locate lose end of the condenser's "water out" tube.
Attach a hose connector (not included) to it.
Attach hose connector your home faucet.
Place the loose end of the "water out" tube to drain into sink basin.
Distilling Configuration
Method 1: Faucet cooling method
Distillate
Copper
Extension Tube
Small
Silicone
Tube
Extending the Distillate Outlet:
Add Small Silicone Tube +
Copper Extension Tube
Hose
Connector
(not included)
Heat Source
Water
Out
Water
IN
13
Publicité
