Publicité
Les langues disponibles
Les langues disponibles
Problem and alarm code
The anti-flood device is on.
•
The end indicator flashes 3 times inter-
mittently.
•
Acoustic signal sounds 3 times inter-
mittently.
Once you have checked the appliance, deactivate
and activate the appliance. If the problem occurs
again, contact an Authorised Service Centre.
THE WASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
There are whitish streaks or blu-
ish layers on glasses and dishes.
There are stains and dry water
drops on glasses and dishes.
The dishes are wet.
Refer to "Hints and tips" for other
possible causes.
TECHNICAL INFORMATION
Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Power consumption
Power consumption
1) Refer to the rating plate for other values.
2) f the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot
water supply to decrease energy consumption.
28
All manuals and user guides at all-guides.com
•
The release quantity of rinse aid is too much. Adjust the rinse
aid selector to a lower position.
•
The quantity of detergent is too much.
•
The released quantity of rinse aid is not sufficient. Adjust the
rinse aid selector to a higher position.
•
The quality of the rinse aid can be the cause.
•
The programme does not have a drying phase or has a drying
phase with low temperature.
•
The rinse aid dispenser is empty.
•
The quality of the rinse aid can be the cause.
Width / height / depth (mm)
Voltage (V)
1)
Frequency (Hz)
Min. / max. bar (MPa)
Cold water or hot water
Place settings
Left-on mode (W)
Off-mode (W)
Possible solution
•
Close the water tap and contact an Authorised
Service Centre.
For alarm codes not described in the table, contact
an Authorised Service Centre.
Possible solution
2)
596 / 818-898 / 555
220-240
50
0.5 (0.05) / 8 (0.8)
max 60 °C
12
0.50
0.50
Publicité
