Publicité
Les langues disponibles
Les langues disponibles
•
Make sure that there are no residues of food or soil in or around the edge of the sump.
•
Put back in place the flat filter (C). Make sure that it is correctly positioned under the 2 guides.
•
Reassemble the filters (A) and (B).
•
Put back the filter (A) in the flat filter (C). Turn it clockwise until it locks.
An incorrect position of the filters can cause bad washing results and damage to the appliance
CLEANING THE SPRAY ARMS
Do not remove the spray arms. If the holes in the
spray arms are clogged, remove remaining parts of
soil with a thin pointed object.
EXTERNAL CLEANING
•
Clean the appliance with a moist soft cloth.
•
Only use neutral detergents.
•
Do not use abrasive products, abrasive cleaning
pads or solvents.
TROUBLESHOOTING
If the appliance does not start or it stops during
operation, before you contact an Authorised
Service Centre, check if you can solve the problem
by yourself with the help of the information in the
table.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
•
The end indicator flashes 1 time inter-
mittently.
•
Acoustic signal sounds 1 time intermit-
tently.
The appliance does not drain the water.
•
The end indicator flashes 2 times inter-
mittently.
•
Acoustic signal sounds 2 times inter-
mittently.
All manuals and user guides at all-guides.com
INTERNAL CLEANING
•
Carefully clean the appliance, including the
rubber gasket of the door, with a soft moist
cloth.
•
If you regularly use short duration programmes,
these can leave deposits of grease and
limescale inside the appliance. To prevent this,
we recommend to run long duration
programmes at least 2 times per month.
With some problems the end indicator flashes
intermittently indicating a malfunction.
Possible solution
•
Make sure that the mains plug is connected to the
mains socket.
•
Make sure that there is no a damage fuse in the fuse
box.
•
Make sure that the appliance door is closed.
•
The appliance has started the procedure to re-
charge the resin inside the water softener. The dura-
tion of the procedure is approximately 5 minutes.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is
not too low. For this information, contact your local
water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clog-
ged.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or
bends.
27
Publicité
