Télécharger Imprimer la page

Bionaire BD20S-CN Manuel D'instructions page 6

Publicité

Trouble
• Dehumidifier
☛ Reservoir is full.
shuts off
automatically.
☛ The compressor starts to
• Signal with 3 long
☛ The unit's sensor detects the room
beep sounds
followed by 2
short ones, and
then the
dehumidifier
automatically
shuts off.
• EO Code on
☛ The sensor malfunctions.
Display.
• Appliance cycles
☛ This is normal operation when
on/off.
• Warm air coming
☛ Heat exchange while the
from outlet grill.
All manuals and user guides at all-guides.com
T R O U b L E S H O O T I N G
TROUbLESHOOTING
Probable Cause
malfunction during the operation.
temperature is below 0 °C or
above 40 °C.
using the automatic
dehumidification setting. The
humidistat within the appliance
adjusts to maintain your desired
comfort level. To run continuously,
select the continuous mode (see
operating instructions).
compressor is on.
Solution
✔ Follow Water Full Protection & Auto-Shutoff
instructions in this manual.
✔ Wait for 3 minutes and then restart the unit
again. If you wish to restart the unit without
waiting for 3 minutes, unplug it from the
electrical outlet and plug it again.
✔ Wait until room temperature is within safe
operating temperature (0-40 °C).
✔ Relocate your dehumidifier to another room
and operate normally. To restart the unit it
will be necessary to unplug it from the
electrical outlet and plug it back in.
✔ Restart the unit after troubleshooting.
✔ This is normal operation.
✔ This is normal operation.

Publicité

loading