Publicité
F E AT U R E S - O P E R AT I O N S
23. CAUTION: In order to avoid a hazard due to
inadvertent resetting of the thermal cutout, this
appliance must not be supplied through an external
switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by the
utility.
PLEASE REAd ANd SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
HOW YOUR dEHUMIdIFIER WORKS
Your Bionaire
dehumidifier draws moisture laden air
®
through the intake grills on the appliance. Humid air
passes through refrigerated coils where the moisture is
removed and collected in the water reservoir.
For optimum performance, it is not recommended to use
this appliance in environments where the temperature
exceeds 37 °C or is lower than 5 °C.
The unit should only be used indoors in such areas as a
living room or bedroom. Never use it outdoors. Make
sure doors and windows are closed before using the
appliance.
PRE-OPERATING INSTRUCTIONS
1. Select a location for your dehumidifier, on a flat/
level surface, about 4 inches (10cm) away from the
wall.
2. Place unit on a stable and flat floor surface. If the
floor surface is not even, there is a risk the unit
might be unstable or topple over. Also, it may result
in excessive vibration and noise.
3. Plug the power cord into a 120V AC electrical outlet.
OPERATING INSTRUCTIONS
Automatic dehumidifying
1. Plug unit into an appropriate electrical outlet. The
unit will beep 3 times. If open, the air oscillator will
return to its closed position.
All manuals and user guides at all-guides.com
2. Press the on/off button to start the unit. The air
3. The auto button enables you to select between
4. Press the auto button once to switch the unit between
5. In automatic dehumidification mode, the unit will
6. In whisper quiet mode, the unit will operate as in the
7. The default humidity level is set at 60% relative
8. To turn the unit off, press the On/Off button again.
Continuous dehumidifying
To set the unit to operate continuously, turn the unit on and
then press the continuous operation button. The unit will
operate in high speed, at 60% RH. When you activate this
mode, the continuous icon will be shown in the LCD display.
NOTE: If you adjust the humidity control buttons during
the continuous operation, the unit will resume the
automatic dehumidification mode.
NOTE: If continuous drain function is not in use and the
water reservoir is not manually emptied, the unit will
automatically shut off when the water reservoir becomes
full.
Using The Timer
Once the unit is powered on and an operating mode is
selected, press the timer button continuously, choosing
from 1 to 8 hours as desired. The timer icon will be
highlighted on the LCD display and show the number of
hours remaining until the unit shuts off.
oscillator will open to its maximum position and
the unit will start the automatic dehumidification
function.
automatic dehumidification and automatic whisper
quiet dehumidification.
automatic dehumidification and whisper quiet
dehumidification.
monitor the relative humidity of the environment and
adjust its functionality accordingly, cycling on and off
to maintain your desired comfort level.
automatic dehumidification mode but at low speed.
The quiet icon will be highlighted in the LCD display.
humidity (RH). Press the humidity control buttons
up and down to adjust the humidity level as desired.
Please refer to the humidity control instructions below
for additional operating instructions.
The air oscillator will close and the unit will stop
working.
Publicité
