Care And Maintenance; Filter Indicator Light; Back Panel And Sensors - Sharp KC-C150U Manuel D'utilisation

CARE AND MAINTENANCE

To maintain optimum performance of this air purifier, please clean the unit including
the sensor and filters periodically.
When cleaning the unit, be sure to first unplug the power cord, and never handle the
plug with wet hands. Electrical shock and/or bodily injury may occur as a result.

FILTER INDICATOR LIGHT

The Filter Indicator Light will illuminate as a reminder to perform mainte-
nance of the Back Panel, Sensors, and Humidifying Filter. The Indicator
Light will turn on after approximately 720 hours of use.
After performing maintenance, reset the Filter Indicator. Plug the unit in,
turn power ON, and press the RESET button for 3 seconds. The Filter
Indicator Light will go off. Even if the filter indicator light is already off, the
RESET button should be pressed to reset the maintenance timer.

BACK PANEL and SENSORS

Whenever dust accumulates
Care Cycle
on the unit or every 2 months
Gently remove dust from the sensor opening and
the back panel, using a vacuum cleaner attach-
ment or similar tool.
SENSOR FILTER CARE
Remove the sensor filter and tap it lightly over a
sink or trashcan to dislodge dust. If it is very dirty,
wash it gently with lukewarm water. Do not use
any detergents or chemicals of any kind to
clean the filter. Dry filter completely before re-
placing in the unit. Do not operate unit without all
filters properly installed.
UNIT
Care Cycle
Whenever dust accumulates on the unit or every 2 months
To prevent dirt or stains on the unit, clean regularly. If stains are allowed to remain, they may
become difficult to remove.
Wipe with a dry, soft cloth
For stubborn stains or dirt, use a soft cloth dampened with warm water.
Do not use volatile fluids
Benzene, paint thinner, polishing powder, may damage the surface.
Do not use detergents
Detergent ingredients may damage the unit.
After 720 hours of use
Care Cycle
(30days ×24hours = 720
Sensor
Back Panel
E-15
Sensor Filter