Care And Maintenance - Sharp FP-J40EU Manuel D'utilisation

CARE AND MAINTENANCE

To maintain optimum performance of this air purifier, please clean the main unit including the filter periodically.
Be sure to disconnect the power cord from the wall outlet before performing any maintenance.
Do not WASH
DEODORIZING FILTER
When the smell from the Air Outlet
When the smell is hard to take
Back Panel ( Pre-Filter )
Once in a month
When the filter reset indicator light is on
BACK PANEL
Back Panel
After
Please reset the filter reset indicator* after
cleaning.
more than
3 sec.
*The Filter Reset Indicator Light will turn on
after approximately 720 hours operating.
SENSORS
Dust sensor
Dust sensor filter
Odour sensor
Be sure to remove the power plug from the wall outlet.
Once in two
SENSORS
months
HEPA FILTER
When the smell from the Air Outlet
When the smell is hard to take
( Pre-Filter )
Gently remove dust from the Back Panel with a vacuum cleaner
attachment or similar tool.
CAUTION
Do not apply excessive pressure when scrubbing the Back Panel.
NOTE
Odour sensor
How to clean hard to remove dirt
1. Add a small amount of kitchen
Back Panel
detergent to water and soak for
about 10 minutes.
2. Rinse off the kitchen detergent
with clean water.
3. Completely dry the filter in a well-
ventilated area.
1. Remove the Back Panel.
2. Remove the Dust Sensor Filter.
3. If it is very dirty, wash it with water and dry it thoroughly.
Gently remove dust from the odour sensor by using a
vacuum cleaner attachment or similar tool.
EN-8
MAIN UNIT
Once in two
months