Cuisinart CBT700E Manuel D'instructions page 16

3. USE
Please wash all the accessories and the jar carefully
before using the appliance for the fi rst time.
CAUTION: handle the blade accessories with extreme
care.
A. Fitting the Jar
• Remove the lid, turn the glass jar (A) upside down and
place it on a level surface.
• Place the rubber seal (B) over the opening on the
bottom of the glass jar.
• Turn the blade assembly (C) upside down and place
16
All manuals and user guides at all-guides.com
the blade end in the glass jar opening. TAKE EXTRA
CARE WHEN HANDLING THE BLADES AS THEY ARE
VERY SHARP.
• Place the locking collar (D) over the blade assembly
and tighten firmly by turning in a clockwise direction.
N.B. The locking collar is fitted with safety interlock
switches (E) which prevent the appliance from
operating if the jar is not fitted correctly. When all
the parts are assembled, turn the glass jar right side
up.
E.
• Fit the lid and cap onto the jar.
N.B. The lid must always be in place when the
D.
appliance is switched on.
• Position the assembled jar on the motor base. The jar
should be facing you.
• Take care when placing the jar on the base. Incorrect
C.
positions could damage the safety interlock switches.
• Plug in the appliance. Your blender is now ready to be
used.
B.
B. Removing the Jar
• Turn the appliance off and unplug from the mains
outlet.
• Remove the jar by lifting from the housing base
(careful: do not dismantle the jar and blade assembly
A.
while it is on the housing base)
• Remove the lid and slowly pour out the contents of
the jar.
• To clean the jar, turn the jar upside down and place it
on a level surface. Twist the locking collar by turning in
an anticlockwise direction.
• Carefully remove the blade. BE VERY CAREFUL WHEN
HANDLING THE BLADE BECAUSE IT IS VERY SHARP.
• Remove the rubber seal.
N.B. Take care not to lose this part as it seals the