Bosch 11250VSR Consignes De Fonctionnement/Sécurité page 16

2610047982.qxp_11250VSR,VSRD 10/2/17 1:01 PM Page 16
Service
Preventive maintenance
performed by unauth-
orized per so n nel may result in misplacing
of internal wires and components which
could cause serious
recommend that all tool service be performed
by a Bosch Factory Service Center or Autho -
rized Bosch Service Station.
TOOL LUBRICATION
Your Bosch tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.
CARBON BRUSHES
The brushes and commutator in your tool
have been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brush es be examined.
Only genuine Bosch replace ment brushes
specially designed for your tool should be
used.
If an extension cord is
necessary, a cord with
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
higher the cord capacity.
* 360° Auxiliary Handle
** Dust extraction system
** Dust cap
** Dust seal
** Dust cap (for hole saws)
** Vacuum adapter dust canister
All manuals and user guides at all-guides.com
Maintenance
Bearings which become noisy (due to heavy
load or very abrasive material cut ting) should
be replaced at once to avoid overheating or
motor failure.
hazard. We
tool from the power supply before
cleaning or performing any main tenance.
The tool may be cleaned most effectively
with compressed dry air. Always wear
safety gog gles when cleaning tools with
compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not at tempt to clean by inserting pointed
objects through openings.
plastic parts. Some of these are: gasoline,
carbon tetrachlo ride, chlo rinated cleaning
solvents,
detergents that contain ammonia.
Extension Cords
RECOMMENDED SIZES OF EXTENSION CORDS
Ampere
Rating
Accessories
** Vacuum hose Adapter
** Vacuum hose
** 3-Jaw Chuck adaptor
* Carrying Case
(*= standard equipment)
(**= optional accessories)
-16-
BEARINGS
Cleaning
To avoid
always dis connect the
Certain cleaning agents
and sol vents damage
ammonia and
120 VOLT ALTERNATING CURRENT TOOLS
Cord Size in A.W.G.
Tool's
Cord Length in Feet
25 50 100 150
3-6 18 16 16 14 0.75
6-8 18 16 14 12 0.75
8-10 18 16 14 12 0.75
10-12 16 16 14 12
12-16 14 12 – –
accidents
house hold
2
Wire Sizes in mm
Cord Length in Meters
15 30 60 120
0.75 1.5 2.5
1.0 2.5 4.0
1.0 2.5 4.0
1.0 2.5 4.0 –
– – – –