2610047982.qxp_11250VSR,VSRD 10/2/17 1:01 PM Page 14
Also replace the microfilter when the
vacuuming performance is insufficient, even
when the dust canister is empty.
VACUUM ADAPTER DUST CANISTER
(Not included, available as accessory)
For dust extraction with a vacuum cleaner, the
(optional) vacuum adapter dust canister can be
inserted into the dust extraction system instead
of the dust canister, if required.
Press the two canister release buttons and pull
canister downward and remove from the dust
extraction system (Fig. 15).
Following a few simple tips will reduce wear on
the tool and the chance of injury to the
operator.
NOTE: The high efficiency available from the
rotary hammers can only be obtained if sharp
and undamaged accessories are used. The
"cost" to maintain sharp and undamaged
accessories is more than offset by the "time
saved" in operating the tool with sharp
accessories.
All hammers require a short period of time to
warm up. Depending on the room temperature,
this time may vary from approximately 15
seconds (90˚F) to 2 minutes (32˚F). A new
hammer requires a break-in period before full
performance is realized. This period may
require up to 5 hours of operation.
Carbide tipped bits: Used for drilling stone,
concrete, cement, brick, cinder block and other
All manuals and user guides at all-guides.com
Install vacuum adapter dust canister upward
into dust extraction system until you hear it lock
into place (Fig. 17).
To use this feature, attach vacuum hose
FIG. 16
(optional accessory) to dust port, then connect
opposite end of the vacuum hose to a shop
MICROFILTER
vacuum cleaner. A vacuum hose adapter
(optional accessory) is available for connecting
this tool to a 1-1/4" or 1-1/2" vacuum hose (Fig. 17).
The vacuum cleaner must be suitable for the
material being drilled.
DUST
CANISTER
FIG. 17
Tool Tips
unusually hard non-metals. The Rotary
Hammer is designed for "SDS" Carbide Tipped
Bits up to 3/4 inch diameter.
Recall these instructions for safe operation:
1. Some materials require slow drilling
speeds; whereas, others require higher speed
to produce the best results.
2. All work must be supported or secured
before drilling and steady, even pressure
applied in line with the drill bit.
3. As the drill bit cuts through the opposite
side, reduce the pressure and continue
running the drill as the bit is withdrawn.
Materials such as glass, porcelain, ceramics,
tiles, plastics, etc., should be drilled at low
speeds with specially designed drill bits and
lubricants.
-14-
VACUUM
ADAPTER DUST
CANISTER
VACUUM
DUST
HOSE
PORT