Wolf Garten UV 30 EV Notice D'instruction D'origine page 12

Operation
Operating times
z Please check noise abatement regulations prevailing in your
country.
Feed cable through the strain relief
z Please feed cable through the strain relief.
Connecting to the mains (230 Volts, A.C., 50 Hz)
z The mower operates from any normal household mains sup-
ply, provided with a 16 Amps. fuse.
3
Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
z We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
z Retrofit kits are available for old installations. Consult an elec-
trician.
Adjust operating depth
Only with motor switched off and non-mowing aeriating roller. The
operating depth must be adjusted to the corresponding grass and
ground conditions.
z Move operating lever towards front
z Increasing the working depth (cutters towards the
ground) L (1)
–
Turn the handwheel "Working Depth Adjustment" to the
right
z Reducing the working depth
–
Turn the handwheel "Working Depth Adjustment" to the left.
(One turn = 1.5 mm working depth)
Maintenance
General
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
z pull out the power plug.
z Do not touch running blades.
12
All manuals and user guides at all-guides.com
J
K
(1).
L
(2)
3
Aeriating test:
z Pull operating lever up again
z Start tool
N
z Push operating lever slowly forward
z Move tool slowly into operating direction
z On hearing stones being hit or blocking of the motor im-
mediately switch off tool
z Turn rotating handle 1–2 rotations towards the left
(2).
z Start aeriating test again
z When used regularly the aeriating depth may be adjusted ac-
cording to the wear of the blade (+).
Recommended working heights
z well kept lawns with stone-free, soft ground
–
Set tool exactly to ground height
z stony, untidy lawns
–
Set tool to ground height
–
Increase working height if stones are thrown up
z unkempt, extremely mossy lawns
–
Start with a high working height
–
Do not overload appliance (reduce working height if motor
blocks)
–
Cut vertically and crossways several times
–
Re-saw with WOLF-Garten >>Loretta<< lawn seeds
Scarifying
1. Depress button N (1) and hold.
N
2. Lift up bar (2) and release button
3. Place lever K (1) slowly into forward position.
4. Switch-off motor: Release bar
1
Important:
Place the cable firmly off the lawn or on the already cut side
of the lawn when starting to mow.
3
Turning (UV 32 EV / UV 34 E)
The cable relief holder enables you to move the cable from one
side of the handle frame to the other. Thus you ensure that the
cable always trails on the ride of the lawn already cut – and not
M
in front of the machine .
Cleaning
z
Clean the unit thoroughly with a brush after each use.
z Do not spray with water.
z Store unit in a dry room.
3
We recommend
Allow a WOLF-Garten-service centre to check the unit in the au-
tumn.
K (2)
K (1)
L
N
(1).
N
(2).
G