Publicité
Les langues disponibles
Les langues disponibles
In order to ensure proper temperatures,
you need to permit
airflow between the refrigerator and freezer sections. As shown in
the illustration, cool air enters the freezer section through vents in
the rear and top. The air flows forward through the freezer section
and recirculates under the freezer floor. Cool air enters the
refrigerator section through the top, flows down and across
shelves to the doors and recirculates to return air vents at the
bottom.
Do not block any of these vents with food packages.
If the vents
are blocked, airflow will be prevented and temperature and
moisture problems may occur.
IMPORTANT: Because air circulates between both sections, any
odors formed in one section will transfer to the other. You must
thoroughly
clean both sections to eliminate odors. To prevent
odor transfer and drying out of food, wrap or cover foods tightly.
The control center is located at the top front of the refrigerator
compartment.
Temperature
Controls
For your convenience, your temperature controls are preset at
the factory. When you first install your refrigerator, make sure the
controls are still set to the recommended
set points as shown.
Recommended
Settings
Warmer
Colder G
0 ° F Recommended
38°F Recommended
FREEZER
REFRIGERATOR
) Warmer
Q
Colder
IMPORTANT:
•
When the power is on, the temperature
display shows the
actual temperature of the compartment.
•
Wait 24 hours for your refrigerator to cool completely before
adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended
setting will not cool
the compartments
any faster.
The recommended
settings should be correct for normal
household refrigerator use. The controls are set correctly
when milk or juice is as cold as you like and when ice cream
is firm.
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not
blocked before adjusting the controls. See "Ensuring Proper
Air Circulation."
To Turn Your Refrigerator
Off/On:
•
Press the freezer (+) touch pad repeatedly until "OFF"
appears in the freezer display. Allow a few seconds for the
refrigerator to shut off. Neither compartment
will cool.
•
Press either the refrigerator or freezer (-) touch pad to turn on
the refrigerator.
Adjusting Controls
The REFRIGERATOR control adjusts the refrigerator
compartment
temperature.
The FREEZER control adjusts the
freezer compartment
temperature.
If you need to adjust the temperature
in either the refrigerator or
freezer compartment,
use the settings listed in the chart as a
guide.
To Adjust Set Point Temperatures:
The first touch of the (+) or (-) touch pad displays the current
temperature set point. The display will show the set point for
approximately
3 seconds, and then return to the actual
temperature.
•
Press the (+) or (-) touch pads until the desired temperature
set point is displayed.
NOTE: Except when first turning on the refrigerator, do not
adjust either temperature control more than one setting at a
time. Wait 24 hours for the temperature to stabilize between
adjustments.
38°F Recommended
@
Warmer
REFRIGERATOR
Colder
CONDITION/REASON:
ADJUSTMENT:
REFRIGERATOR too warm
Adjust REFRIGERATOR
- Door opened often, large amount
TEMPERATURE Control
1o lower
of food added or room
temperature very warm
FREEZER too warm/ice not made
fast enough
- Door opened often, or large
amount of food added or very cold
room temperature (can't cycle
often enough)
- Heavy ice usage
Adjust FREEZER
TEMPERATURE Control
1o lower
REFRIGERATOR too cold
Adjust REFRIGERATOR
- Controls not set correctly for
TEMPERATURE Control
your conditions
1° higher
FREEZER too cold
Adjust FREEZER
- Controls not set correctly for
TEMPERATURE Control
your conditions
1° higher
11
Publicité
