Rothenberger ROCAM 4 Instructions D'utilisation page 36

 Loosen locking bolts by pulling gently from the lock and Turning it 90 °. Restrain reel (8) to
prevent from slipping.
 Push reel (8) toward T-slot and remove the side. Use caution not to damage the connector.
 Mount in reverse order, paying attention when inserting the reel (8) on mark.
The software automatically detects the connected camera head.
4 Care and Maintenance
Always clean the device after every pipe inspection!
 Turn the device off with the power button on the monitor (7) and remove the battery, and pull
the electrical plug.
 Close the cover and press until it clicks.
 Take off the reel (8) from the ROCAM
 Only clean the reel when removed from device.
The device must be protected against water and must only be cleaned with a damp
cloth!
 Insert dried reel (8) back into the device (see section 3.11).
Charger:
If the supply cord of this product is damaged, it must be replaced by an authorized repair shop
appointed by the manufacturer, because special tools are required.
5 Accessories
Accessory Name
Mini-Modul
Camera head 30 mm
Camera head 40 mm
Guide ball for brush tool 30 mm
Guide ball for brush tool 40 mm
Brush tool Ø 100 mm
Brush tool Ø 150 mm
Roll carriage for 40 mm Ø 150 mm
Roll carriage for 40 mm Ø 200 mm
Power supply 230 V
6 Customer service
The ROTHENBERGER service locations are available to help you (see listing in catalog or on-
line) and replacement parts and service are also available through these same service locations.
Order your accessories and spare parts from your specialist retailer or using our service-after-
sales hotline:
Phone: + 49 (0) 61 95 / 800 – 8200
Fax: + 49 (0) 61 95 / 800 – 7491
Email: service@rothenberger.com
www.rothenberger.com
32
All manuals and user guides at all-guides.com
®
4 (see section 3.11) and clean under running water.
ROTHENBERGER- Part Number
1500001472
1500000123
1500000122
1500000817
69112
69113
69117
69118
69119
1500001562
ENGLISH