Rothenberger ROCAM 4 Instructions D'utilisation page 29

All manuals and user guides at all-guides.com
In the event of other faults, please contact ROTHENBERGER Service. Repairs should only be
carried out by ROTHENBERGER service centres or dealers authorised by ROTHENBERGER.
3.4 Changing the battery
 Open the rear cover (5).
 Insert the battery into the compartment on the right side of the accessory compartment until
it clicks. To remove, press the locks and pull the battery out.
3.5 Working with the device
Wear protective clothing! Always stand next to the reel cable!
 Push reel cable (4) with bending spring (3) from the holder (10) / reel (8) take and remove
cap.
 Remove the cap from the camera head (1) and screw on the bending spring (3).
Caution: Check for cleanliness and damage!
 If necessary, additional accessories can be attached to camera. When using pipe diameters
greater than 70 mm, always use guide body!
 Clean the pipe system before inspection.
 Press button on the bottom cover (6), open the cover. Hold the door during opening.
 Turn the device on with the Power-button, located bottom front center of the monitor (7). The
monitor unit (7) can be removed from the basic device for optimal viewing angle.
Excessive pressure on the touch screen may damage the monitor unit!
 Remove the camera head (1) from the holder (10) and pull the cable (4) from the reel (8).
The cable is rigid and is under mechanical stress. Therefore, hold it firmly when unwinding
from the reel. By pressing in the holder / bracket (10), it can be clamped!
 Guide the camera head (1) into the pipe system and carefully push it with the cable (4). Cau-
tion: Unwinding the reel too quickly may cause it to continue to spin.
 For optimal results, a camera head (SL40) with a stronger light yield up to DN300 can be
screwed on. Camera heads are interchangeable.
Do not pull the cable (4) over sharp edges, and do not bend it!! Check the camera
cable before each use for damage!
While it is being pushed, the cable (4) may loop: Breakage may result!!
During advancement through several pipe bends, the camera image is always upright.
 After work is finished, pull the cable (4) out of the pipe and push it directly onto the reel (8).
Remove coarse dirt and water with a rag while winding cable on reel.
 Clean thoroughly (see section 4.).
 Dismantle camera head (1) and accessories, plug cap and insert bending spring (3) with rell
cable (4) into the reel (8).
 Camera head (1) and accessories should be cleaned and safely stored.
 Close the flap.
Camera head and accessories must be cleaned after each use, dismantled and
stored safely. Abnormal transport of the camera head can cause damage!
 Check the camera head regularly the camera head (1) for leaks. For this purpose, screw the
test adaptor on the camera head, applying a maximum pressure of 1 bar by an air pump
with pressure indicator. If this test indicates a drop in pressure, replace camera head.
ENGLISH 25