Table Des Matières; Introduction; Owner Responsibility; Product Description - pullman Ermator W 70 P Manuel D'utilisation

Introduction..................................................................... 2
Safety..............................................................................4
Assembly........................................................................ 5
Operation........................................................................ 6

Owner responsibility

WARNING: Cutting, especially when DRY
cutting, generates dust that comes from the
material being cut, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability to
breathe), including chronic bronchitis,
silicosis and pulmonary fibrosis from
exposure to silica. These diseases may be
fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Wear and ensure that all bystanders wear
appropriate respiratory protection such as
dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
To minimize dust emissions, wet cut when
feasible. If dry cutting is necessary, use an
appropriate dust extractor.
It is the owner's/employer's responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator's Manual. They must
be aware of:
2
Contents
Maintenance................................................................... 7
Troubleshooting.............................................................. 8
Transportation, storage and disposal............................. 9
Technical data.............................................................. 10

Introduction

• The products's safety instructions.
• The products's range of applications and limitations.
• How the product is to be used and maintained.
National/Local regulations could restrict the use of this
product. Find out what regulations are applicable where
you work before you start using the product.

Product description

The Pullman Ermator Wet industrial vaccum cleaner is a
slurry collector. The liquids are sucked through the inlet
valve at high speed via the suction hose. The liquid is
collected in a container. The pump variants offer the
possibility to evacuate the liquid via the evacuation
pump.
On variants without the evacuation pump the liquid can
be drained by the evacuation valve.
A floating device protect the motor from liquid.
The W 70 and W 70 P have an extra filter to filter the
slurry foam from particles.
To protect the product and prolong the lifetime it is
always recommended to use bags to collect and filter
the largest particles.

Intended use

The product is intended for domestic and commercial
use to vacuum and collect liquid none explosive,
flammable or combustible.
The W 70 and W 70 P can be used for dry applications
temporarily. Dry bags should then always be used and
the filter should be changed to a Hepa filter, sold as an
accessory.
915 - 002 - 02.04.2019