Publicité
Les langues disponibles
Les langues disponibles
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
After you connected the effect to the mains, the EUROLITE WMB-4 RGB 10mm LED Bar starts running.
The LCD display lights up and you can choose the desired mode via the MODE button:
- STAND ALONE-MODE
- AUTO MODE
- DMX MODE
- MASTER/SLAVE MODE
- SOUND CONTROL MODE
STAND ALONE-MODE
Chaser
A chaser is a sequence of different steps that will be called up one after another in a continuous loop. With
WMB-4 RGB 10mm LED Bar, you can select up to 14 different chasers.
Selecting a chaser
Press the SET UP button. Select the desired chaser (00 – 14) via the UP or DOWN buttons
Select the desired chaser value via the UP or DOWN buttons. . (Step Time/Sp oder Flash Speed/Fs)
Fs (Flash Speed) from 00 to 100%.
Sp (Step Time) from 001 to 100 times/minute.
The desired values can be selected via the UP or DOWN buttons.
AUTO MODE
In Auto Mode the chasers are called up automatically in a continuous loop.
The desired frequency of the loops can be selected via the UP or DOWN buttons.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the WMB-4 RGB 10mm LED Bar will respond to the controller.
Addressing
Press the SET UP button until the display shows DMX MODE dmx address:001.
Set the desired address via the UP or DOWN buttons.
Controlling:
After having addressed the WMB-4 RGB 10mm LED Bar, you may now start operating it via your lighting
controller.
Note:
After switching on, the WMB-4 RGB 10mm LED Bar will automatically detect whether DMX 512 data is
received or not. If the data is received, the control LED flashes. If there is no data received at the DMX-input,
the control LED lights up permanently.
This situation can occur if:
19/41
51930280_V_1_0.DOC
Publicité
