EuroLite WMB-4 RGB Bar 10mm LED Lighting Effect Mode D'emploi page 20

- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of WMB-4 RGB
10mm LED Bar.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX Channel Selection : Choosing a DMX Channel Mode in 26 Channal Occupation
Press the SET UP button until the channel modes appear on the LCD display. (channel num: 26, channel
num: 14, channel num: 8, channel num: 5)
Set the desired mode via the UP or DOWN buttons.
If the DMX value is less than 251, then the Dimmer occupies the first channel and the Flash occupies the
second channel.
14-Channel Mode:
8-Channel Mode:
5-Channel Mode:
If the DMX value during the above described settings and the first channel is equal to or more than 251, then
the device uses the follwoing DMX Protocol:
20/41
Every spot occupies 3 channels.
Four spots occupy 12 channels.
The device occupies 14 channels
Every spot occupies 3 channels
Four spots occupy 6 channels
The device occupies 8 channels
Every spot occupies 3 channels
Four spots occupy 3 channels
The device occupies 5 channels
51930280_V_1_0.DOC