Sony SU-FL62 Mode D'emploi page 16

CAUTION
If the following precautions are not observed,
injury or property damage may occur.
Do not install any equipment other
than the specified product.
• This Floor Stand is designed for use with the specified
product only. If you install equipment other than specified,
it may fall or break, and cause injury.
• Do not place objects such as vases, pottery, etc., on the
Floor Stand.
• Do not modify the Floor Stand.
• Do not place anything hot directly on the Floor Stand. The
heat may cause discoloration or deformation of the Floor
Stand.
• Do not place anything directly on the Floor Stand that may
damage the glass.
Be sure to secure the TV.
Secure the TV to the Floor Stand using the supplied lock
screws. If the TV is not installed securely, it may fall or the
Floor Stand may topple over, and cause injury.
Do not apply weight to the glass or
subject it to any kind of impact.
Do not apply weight to the Floor Stand with your hand when
installing the TV. Do not hit the Floor Stand with hard
objects, such as a screwdriver, etc. The glass may break and
cause injury.
When carrying the Floor Stand
Trying to move the Floor Stand alone, or without following
the proper procedures, may cause injury. To avoid this, be
sure to follow the advice given below.
• Be sure that two or more persons carry the Floor Stand,
and only after removing the TV, connected equipment and
glass shelves.
• Do not drag the Floor Stand. The base parts of the Floor
Stand may come off and damage the floor.
• Be careful not to allow your hands or feet to be pinched
under the bottom plate.
• Do not grab the glass shelf when carrying the Floor Stand.
4
(GB)
Do not subject the glass to
excessive shock.
This Floor Stand is made of
tempered glass, but care should
be taken.
If the glass breaks, glass
fragments could cause injury, so
observe the precautions below.
• Do not hit the glass or drop
sharp-pointed objects on the
glass. Avoid excessive shock.
• Do not scratch or poke the
glass with sharp-pointed
objects.
• Do not let hard objects such
as a vacuum cleaner hit the
edges of the glass.
Note on carrying capacity
Do not place any equipment
which exceeds the maximum
weight for each shelf as
indicated in the illustration.
Otherwise, the shelves may
break.
Notes on installation
• When assembling, lay the packing materials on the floor to
avoid damage to the floor.
• Install the Floor Stand on a solid and flat floor. Do not
allow the Floor Stand to be installed at an angle or incline.
To avoid this, observe the following precautions.
– Do not install the Floor Stand in a place subject to direct
sunlight or near a heater.
– Do not install the Floor Stand in a hot or humid place, or
outdoors.
Note on use
To keep the Floor Stand clean, occasionally wipe it with a dry
soft cloth. Stubborn stains may be removed by wiping with a
cloth slightly dampened with mild soap. Be sure to dry the
area afterwards with a dry soft cloth. Do not use chemicals,
such as thinner or benzine, as they damage the finish of the
Floor Stand.
20 kg (44 lb 2 oz)
30 kg (66 lb 3 oz)