Sony CDX-G3300UV Mode D'emploi page 20

The sound cannot be output during
playback in Android mode.
 Check the status of the audio playback
application on the Android smartphone.
Messages
The following messages may appear or flash
during operation.
INVALID: The selected operation could be
invalid.
READ
 Wait until reading is complete and
playback starts automatically. This may
take some time depending on the file
organization.
(underscore): The character cannot be
displayed.
For CD playback:
CD ERROR
 Clean or insert the disc correctly, or make
sure the disc is not blank or defective.
CD NO DISC
 Insert a disc containing playable files
(page 17).
CD NO MUSIC
 Insert a disc containing playable files
(page 17).
CD PUSH EJT: The disc could not be ejected
properly.
 Press  (eject).
or : The beginning or the end
of the disc has been reached.
20
GB
For USB device playback:
HUB NO SUPRT: USB hubs are not
supported.
IPD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start
playback.
NOT SUPPORT ANDROID MODE
 A USB device not supporting AOA
(Android Open Accessory) 2.0 is
connected to the unit while [USB MODE] is
set to [ANDROID].
– Set [USB MODE] to [MSC/MTP] (page 13).
USB ERROR
 Connect the USB device again.
USB NO DEV
 Make sure the USB device or USB cable is
securely connected.
USB NO MUSIC
 Connect a USB device containing playable
files (page 17).
USB NO SUPRT
 For details on the compatibility of your
USB device, visit the support site on the
back cover.
USB OVERLOAD: The USB device is
overloaded.
 Disconnect the USB device, then press SRC
to select another source.
 The USB device has a fault, or an
unsupported device is connected.
For RDS operation:
NO AF: No alternative frequencies.
 Press / (SEEK –/+) while the
program service name is flashing. The unit
starts searching for another frequency
with the same PI (program identification)
data ([PI SEEK] appears).
NO PI: No program identification. The
selected station has no PI (program
identification) data.
 Select another station.